Xh-m608 Manual ✓ [POPULAR]

I can provide the exact you need to program into your device. Share public link

Press the left button to increase the voltage or the right button to decrease it.

The is a highly versatile, programmable voltage protection board designed to safeguard and manage DC 6–40V battery setups. Featuring an integrated digital voltmeter, precise sub-menu controls, and an on-board relay, it serves multiple functions: an overvoltage/undervoltage safety cutout, an automated battery charger controller, and a time-controlled discharge switch. Xh-m608 Manual

Set the voltage where the load should once the battery recharges (e.g., 12.6V). Hold SET for 3 seconds to save. 5. Troubleshooting Common Issues Issue 1: Screen Does Not Turn On Cause: Input voltage is below 6V or terminals are reversed.

*Sources: *

Designed for charging profiles. The relay closes (turns ON) when the voltage drops to the P1 limit to start charging, and opens (turns OFF) when the voltage reaches the P2 limit to prevent overcharging.

To protect a 12V battery from over-discharge (e.g., for a DC pump or lights), connect as follows: I can provide the exact you need to program into your device

Note: The module uses a high-side switch. The Relay terminals break the connection to the positive side of the charger or load. 3. Programming Instructions (Setting the Parameters) uses a simple "Set", "Add" (+), "Decrease" (-) interface. A. Setting the Low Voltage Protection (Stop Discharge)

The relay closes (starts charging) when the battery drops to the lower limit and opens (stops charging) when it reaches the upper limit. "Decrease" (-) interface. A.

These connect to the battery source being monitored. The board draws its logic operating power directly from this terminal, which must stay within the DC 6–40V constraint.

While the Xh-m608 is designed to be reliable, you may encounter issues. Here are some common problems and solutions: