Do not run signal cables in parallel with AC control wiring or frequency converter power cables. Use dedicated wire ducts for low-voltage signals.
Once the installation is complete, restart your computer to ensure the new drivers are properly loaded. gea+gforce+panel+manual+install
Run signal cables through dedicated wire ducts, avoiding proximity to power cables. : Do not run signal cables in parallel with
Unlike the auto-installer, manual mode requires you to install base packages first: oil pump starters
: Use two-conductor shielded cables for signals, ideally twisted pairs. These should be separated from AC control wiring to prevent interference.
Connect the load/unload solenoids, oil pump starters, and liquid injection solenoids.
This step involves connecting the GEA GForce Panel as a peripheral to a host system.